If you own a home or rent a house that was built or updated in the last ten years, you probably have a smart meter on the wall. It looks like the old analog meter with the spinning metal disk, but it does something different. Instead of waiting for a person to walk up and copy the dials, the meter itself sends your usage to the utility through a wireless network.
The meter records how much electricity you use in short stretches. It might be every fifteen minutes or every hour. Nobody in the utility office can tell what you plug in or which appliance is running. They just see a number that goes up. The meter sends that number in a short radio burst, then goes quiet. The pattern repeats based on how the utility set its network. Some meters send every few hours. Others send more often. The radio is not on all the time.
Published measurements taken near these meters show that the radio signal during a burst stays well within the limits the FCC allows, and the level falls off fast once you step away. The distance between you and the meter does almost all the work of reducing exposure. If you are in a bedroom on the other side of the wall from the meter, the signal is much weaker than it is right at the box.
The old analog meter had no radio and no way to send data. A person had to come read it once a month. That cost money in wages and truck fuel. That is the main difference. The smart meter saves the utility that expense and gives them more detailed data about when people use power.
Some people do not want a radio in their meter. Most utilities will swap the smart meter for an older one without a radio. This is called opting out. It is not free. The utility has to send someone to read the meter by hand, and they charge for that. There is usually a one-time fee when they make the swap, plus a monthly charge that appears on your bill. The amounts are not the same everywhere. Some utilities, including the large ones in California, offer a lower rate for low-income customers.
If you want to know the exact fee for your house, look at your utility’s tariff. That is the official document that sets the rates and charges. It will tell you what the opt-out fees are and whether there is a discount available. If you have questions about whether the radio signal from the meter is safe for your health, that is a question for your doctor. If you wonder whether the utility is charging you correctly, that is a question for the utility or for your state’s public utility commission. If you believe the meter is not meeting FCC rules, that is a matter for the FCC itself.
There is a fuller write-up at smart meters in plain numbers.
